Handheld Electric Frother Manual

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be followed, including the following:

Carefully read all the instructions before operating the appliance for the first time and refer back for future reference.
Remove and safely discard any packaging materials before using the frother for the first time.
To protect against electrical hazards, do not immerse the frother handle in water or any other liquid, or allow moisture to come into contact with that part. This will lead to irreparable damage to the frother.
Do not operate the frother near the edge of a counter, table or bench.
The frother has been designed specifically for the purpose of foaming milk (including plant-based milk) and mixing powders into liquids, and is not intended to whip, or thicken food substances such as oil, eggs, butter, heavy whipping cream, soups, gravies, etc.
The frother is not designed to mix a large quantity of dry ingredients.
Keep the frother clean. Strictly follow the care and cleaning instructions described in this manual.
Do not use harsh abrasive, caustic cleaners or oven cleaners when cleaning the frother.
This appliance is for household use only. Do not use the frother for anything other than its intended purpose as described in this manual.
This frother is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the frother.
Regularly inspect the USB charging cable and frother handle for any damage. Do not operate if damaged in any way or after the frother malfunctions. Immediately cease use of the appliance and contact Landish at 1-888-997-3629 or hello@landish.ca
This frother is equipped with a removable USB charging cable with a type Micro-USB port that inserts directly into the frother handle. The other end can be plugged into a computer/power bank or charger.

⚠ WARNING
Never immerse the frother handle in water or allow moisture to come into contact with this part. It is not waterproof.

TECHNICAL SPECIFICATIONS

Colour: White

Power: 2.5W

Voltage: 4.5V ~ 5.5V

Charging time: 6 hours

Power supply: USB charging cable

Built-in battery: 1200 mAh rechargeable lithium battery

Rotating speeds: 3500 RPm, 8500 RPm and 13500 RPm

BEFORE FIRST USE / OPERATING

Ensure you have all parts and accessories: frother handle, metal whisk head and USB charging cable.

Remove and safely discard all packaging materials attached to the Landish Handheld Electric Frother.

BEFORE THE FIRST USE, CHARGE YOUR FROTHER COMPLETELY.

It takes ~6 hours to fully charge the frother. To charge, plug the frother into any USB port such as a power bank, desktop computer, laptop, or USB wall charger (not included). Red power light indicates the frother is charging and green power light means it is fully charged.

Clean the metal whisk head in a cup of warm water and mild detergent. To do this, place the whisk head into the water and then press the “low” button. Guide the frother in slow, circular movements for ~10 seconds. Press the “low” button again to completely turn off the frother before lifting it out of the water. Rinse with running water and dry thoroughly.

NOTE
If any dirty residue remains on the metal whisk head, clean it off with a cloth or sponge.

Clean the exterior of the frother handle with a soft damp cloth and wipe dry. For stubborn residues, use a mild detergent on the cloth.

Avoid abrasive pads, cloths, and cleansers, that can scratch or otherwise damage the surface.

HOW TO USE OUR HANDHELD ELECTRIC FROTHER

1. Fill a receptacle with liquid (milk, water, etc.). Always whisk in a receptacle that's no more than 40% full to prevent spilling.

NOTE: overfilling may result in spilling, while underfilling prevents the whisk from working optimally.

2. Add one serving of Landish latte mix, collagen, SmarterGreens, SmarterBerries, or other powder.

3. Ensure metal whisk is securely attached to the frother handle before placing it into the bottom of the receptacle.

NOTE: if whisk is not inserted correctly into the frother handle, it may start shaking abnormally when turned on. Always insert the metal whisk into the frother handle when the frother is turned off.

4. WE RECOMMEND ALWAYS PLACING THE METAL WHISK INTO THE RECEPTACLE FILLED WITH THE LIQUID FIRST before turning on the frother. We also recommended turning off the frother, while the metal whisk is still in the receptacle filled with the liquid, before lifting it out.

NOTE: this frother is equipped with three different speeds: low, medium and high. Selecting the wrong speed will cause spilling. To avoid this, start by pressing the “low” speed button first before adjusting to the “mid” or “high” speed buttons.

5. Guide the frother in slow, circular movements. No need to hold the button down while the frother is turned on.

6. When milk is frothy enough or when powder is completely dissolved, press the last selected button to turn off the frother.

7. Lift the frother out of the receptacle.

8. Clean the whisk head immediately after use in a glass or cup filled to ⅓ with warm water and mild detergent. To do this, place the whisk head into the water and then press the “low” button. Press the “low” button again to completely turn off the frother before lifting it out of the glass or cup. Rinse with running water and dry thoroughly.

NOTE: If any dirty residue remains on the whisk, clean it off with a cloth or sponge.

Clean the exterior of the frother handle with a soft damp cloth and wipe dry. For stubborn residues, use a mild detergent on the cloth.

Avoid abrasive pads, cloths, and cleansers, that can scratch or otherwise damage the surfaces of the frother.

TIP: When making hot milk froth, do not heat the milk to more than 60°C/140°F. Otherwise, the milk will not froth properly.

CAUTION: Always make sure the frother is completely turned off when inserting into the receptacle or before lifting it out of any liquid. Otherwise, liquid may spill.

After every 20 minutes of continuous use, allow a 15 minutes break for the frother to cool down. Exceeding this operating time may damage the motor and battery.

WARNING: Don’t drop the frother or bend the metal whisk.

CARE & CLEANING

Clean the metal whisk shaft and head immediately after each use to prevent build-up of residue.

Fill a glass or cup filled to ⅓ with warm water and mild detergent.
Submerge the whisk head in the water and then press the “low” button.
Guide the frother in slow, circular movements for ~10 seconds.
Press the “low” button again to completely turn off the frother before lifting it out of the water.
Rinse with running water and dry thoroughly.
Clean the exterior of the frother handle with a soft damp cloth and wipe dry. For stubborn residues, use a mild detergent on the cloth.

NOTE: If any dirty residue remains on the metal whisk, clean it off with a cloth or sponge.

Do not use alkaline or abrasive cleaning agents, steel wool, or scouring pads on any part of the Handheld Electric Frother as these can damage the appliance’s surfaces.

⚠ WARNING
Never immerse the frother handle in water or any other liquid. It is not waterproof.

PRO TIPS

It takes ~6 hours to fully charge the frother.
Always whisk in a receptacle that's no more than 40% full to prevent spilling.
Always place the metal whisk into the receptacle filled with liquid first before turning on the frother.
Always turn off the frother, while the metal whisk is still in the receptacle filled with the liquid, before lifting it out.
Some milks produce more froth than others. For example, we have found that some oat milks produce very airy froth, while others do not. Experiment with different milk options to achieve the desired results.

ENVIRONMENT

Please recycle packaging materials, such as paper and cardboard.

When this appliance reaches the end of its useful life, bring it to a collection point for the reuse or recycling of electrical and electronic equipment. Do not dispose of it with general household waste. Contact your local authority to locate a collection point near you.

TROUBLESHOOTING

Whisk is vibrating or wobbling?

Possible causes:

Whisk is not inserted into the frother handle correctly
Whisk is bent/curved*
Frother needs to be charged

What to do:

Ensure the whisk is securely and correctly attached to the frother handle
*If whisk is bent/curved, it should be replaced. Please contact us at hello@landish.ca
If the power light is flashing, it means the frother is low on power and should be charged

Liquid is splashing and/or spilling?